Your water heater is one that is used and much more costly appliances in your home, and consumes a large regarding your energy dollars each month. And experts say regular care and maintenance is essential to protecting your investment and saving around the home heating as well as costs.
Regular flushing of one’s water heater is probably the single most important step you get to prolong its service life in addition, it save energy. During time, sediments mount up in the bottom of your hot water heater. These sediments act as a barrier between the flame and the tank, thereby making your heater burn longer and hotter. In part destructive to the tank, but highly inefficient and will significantly raise your heating costs.
In most regions of the country, the average water heater lasts 3-5 years. Regularly flushing your hot water heater can double the life of your water heater from 3-5 to 7-10 years. Are investigating costs of replacement running from $700 to over $1200 in some cases, getting the most out of your heater is a must in today’s markets. In addition, regular flushing makes your hot water heater run more efficiently and can cut heating costs fifty percent. Depending on the volume of drinking water your home uses, that can mean a savings of $20 to over $50 a week.
To drain your water heater, initially you should set the thermostat to pilot (if it is really a gas water heater) or turn the circuit breaker off (if it is an electric heater). Failure to do so could result in overheating and severe damage to the heater. Next, close the water supply valve located on the water inlet line going into your water heater. Equipped to connect a hose to the drain valve located towards the bottom of the hot water heater. Open the drain and allow it to function until all on the water has emptied from the heater. Then close the drain. Open the water supply valve and refill the heater. You should also open a hot water faucet somewhere inside and stand there and watch it run for several minutes until drinking water flows out perfectly. This will allow air to vent via the heater and the hot water lines. Finally, you can turn the thermostat for you to its regular setting (for a gas heater), or turn the circuit breakers back on (for an electric heater).
Besides regularly flushing your water heater, plumbing experts also advise adding a water treatment system to your home to filter or condition the water so it is less corrosive to your plumbing system, particularly in areas which have hard hot water. For more ways to care for and protect your home plumbing system, contact a licensed, professional plumbing contractor in location to discuss options and products to provide what you need.
Abacus Plumbing, Air Conditioning & Electrical
The Woodlands, TX
(281) 528-1610
